True/False
Indicate whether the sentence or statement is true
or false.
|
|
|
1.
|
One
of the purposes of a planer is to straighten a warped board.
|
|
|
2.
|
The
cutting head is mounted below the table, so when you pass stock through the planer, only the bottom
of the stock is surfaced.
|
|
|
3.
|
You
should always stand to one side when planing stock, never directly behind the board.
|
|
|
4.
|
When
tailing off, pull gently on the board being planed to help it move through the planer
smoothly.
|
|
|
5.
|
To
surface several short pieces of the same thickness, butt the ends together as they are fed through
the planer.
|
Completion
Complete each sentence or
statement.
|
|
|
6.
|
The
part of a planer that prevents the grain from tearing out as a board is fed through the planer is the
_____. (two words)
|
|
|
7.
|
Boards to be planed must be _____ inches longer than the distance between feed
rolls.
|
|
|
8.
|
When
you are planing very thin stock, you should use a(n) ____ that is at least 3/4 inch thick. (two
words)
|
|
|
9.
|
A
small, concave cut that sometimes occurs at the end of the stock being planed is called a(n) _____,
or snipe.
|
|
|
10.
|
The
part of the planer that surfaces the board to the desired thickness is the _____.
|
|
|
11.
|
The
_____ of the planer indicates the maximum width and thickness that can be surfaced.
|
Matching
|
|
|
|
|
|
12.
|
infeed roll
|
|
|
13.
|
cutterhead
|
|
|
14.
|
pressure bar
|
|
|
15.
|
outfeed roll
|
|
|
16.
|
chip
breaker
|
|
|
17.
|
gib
|
|
|
18.
|
knife
|
|
|
a. | Step
1 | e. | Step
5 | b. | Step
2 | f. | Step
6 | c. | Step
3 | g. | Step
7 | d. | Step
4 | | | | |
|
|
|
19.
|
Turn
on the power and engage the feed control.
|
|
|
20.
|
Adjust the machine to 1/16 to 1/8 less than the thickness of the board at its thickest
point.
|
|
|
21.
|
Check
the stock and then reset for thickness if another cut is to be made.
|
|
|
22.
|
Measure the thickness fo the board at its thickest point.
|
|
|
23.
|
Start
the stock into the planer and remove your hands.
|
|
|
24.
|
Walk
around to the back and hold the surfaced end of the board up as the remainder of the board passes
through the machine.
|
|
|
25.
|
Place
the working face of the stock on the table so that it feeds with the grain.
|