Matching
|
|
|
|
|
|
1.
|
open
|
|
|
2.
|
round
|
|
|
3.
|
blind
|
|
|
4.
|
through
|
Completion
Complete each sentence or
statement.
|
|
|
5.
|
The
_____ of a mortise is the same as the thickness of the tenon.
|
|
|
6.
|
The
_____ of a tenon depends on whether the mortise is a blind or through mortise.
|
|
|
7.
|
The
rectangular hole cut in wood is known as a(n) _____.
|
|
|
8.
|
A(n)
_____ mortise is one that is cut all the way through the piece of wood.
|
|
|
9.
|
The
projecting piece of wood shaped to fit into the hole in a mortise-and-tenon joint is the
_____.
|
|
|
10.
|
When
a(n) _____ mortise is used, the end of the tenon cannot be seen when the parts are
assembled.
|
|
|
11.
|
The
width of a tenon should be _____ inches or less.
|
|
|
12.
|
When
cutting a mortise using hand tools, you can use a(n) _____ chisel to remove the waste
stock.
|
|
|
13.
|
Cut a
small _____ around the end of a tenon to help it slip easily into the mortise.
|
True/False
Indicate whether the sentence or statement is true
or false.
|
|
|
14.
|
A
mortise-and-tenon joint is a very strong joint that can withstand pressures that might force other
joints apart.
|
|
|
15.
|
When
using a mortising machine, mortises should be sized according to the standard sizes of mortising
chisels.
|
|
|
16.
|
When
cutting the pieces for a mortise-and-tenon joint, you should plan to cut the tenon
first.
|
|
|
17.
|
The
thickness of the tenon should be between one-third and one-half the thickness of the piece in which
the mortise is cut.
|
|
|
18.
|
A
drill press can be used to make the cuts for a mortise-and-tenon joint.
|
|
|
19.
|
The
speed at which a mortising machine is run depends on the size of the chisel and the wood’s
density.
|
|
|
20.
|
The
tenon should fit into the mortise loosely to allow room for gluing.
|